 Fig.1
|
If you need several bends within one session of the plug-in, then you should start (as you have already guessed) from the Bend #1.
Once you did it, click the Add button in the Bends palette (Just be sure that this palette is activated.) and add one more bend and then,
choose the type of the bending (curling or folding) by selecting the appropriate check box. You may add up to 25 bends and, of course, either bend is fully adjustable at
any time within the plug-in session. (See Fig.1)
When you add a new bend, it will always be added with the default settings (In particular, the default type of bending is curl.) each time onto the same place -
bottom right area of the page. In the Preview area of the Surface panel, you will see the color triangle, which represents this bend, in the bottom right corner.
Then, use the Surface panel controls to obtain the desired look of this bend.
In the Surface panel's Preview, the active bend (in other words, the bend, which parameters you are adjusting) is indicated by the semitransparent green-colored
overlay. Any other bend (if presents) is indicated by the semi-transparent blue-colored overlay. The shape of the overlaid area depends on the particular bend's parameters.
|